8MM FORUM WORLDWIDE https://8mmforumworldwide.com/
POWER CORD NEEDED CHINON 7000 FOUND!! https://8mmforumworldwide.com/viewtopic.php?f=6&t=277	Page 1 of 1

---

Author:	Pasquale DAlessio [ Mon Sep 26, 2011 7:08 pm ]
Post subject:	POWER CORD NEEDED CHINON 7000 FOUND!!
OK Does anybody have a spare power cord for a Chinon 7000 dual 8mm projector It has the round type pins NOT the flat PC type. See attached pic. The space between pins is 5/8" center to center. Thanks PatD Attachments: DSCF0002.JPG [ 128.96 KiB | Viewed 3008 times ]

---

Author:	Dan Lail [ Mon Sep 26, 2011 8:33 pm ]
Post subject:	Re: POWER CORD NEEDED CHINON 7000
That looks like the old waffle iron power cord.

---

Author:	Pasquale DAlessio [ Mon Sep 26, 2011 8:46 pm ]
Post subject:	Re: POWER CORD NEEDED CHINON 7000
Close but no cigar. The prongs on an iron, coffe pot cord etc. are spaced futher apart. The spacing on these is 5/8". A bit smaller.

---

Author:	Dan Lail [ Mon Sep 26, 2011 9:55 pm ]
Post subject:	Re: POWER CORD NEEDED CHINON 7000
Here's one for $28.99. I know that is too much money, but it lists all the type units this cord will fit. You may be able find oline by using those names. http://www.oaktreevintage.com/Sansui_AC ... cement.htm This is on Ebay. You could ask the seller what the spacing is. http://www.ebay.com/itm/VINTAGE-SONY-12 ... 1c1c7e1063

---

Author:	Pasquale DAlessio [ Tue Sep 27, 2011 2:57 am ]
Post subject:	Re: POWER CORD NEEDED CHINON 7000
Thanks Dan!

---

Author:	John Capazzo [ Sat Oct 01, 2011 7:55 pm ]
Post subject:	Re: POWER CORD NEEDED CHINON 7000
Pat, Did you find the cord? I am pretty sure I have it. Email me. John

---

Author:	Pasquale DAlessio [ Tue Oct 04, 2011 3:51 pm ]
Post subject:	Re: POWER CORD NEEDED CHINON 7000 FOUND
John I got one from Jim Seaburg. Thanks PatD

---

Page 1 of 1	All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/