8MM FORUM WORLDWIDE • View topic - Lower pulley vibration on ELMO 1200? PROBLEM SOLVED

8MM-16MM FORUM WORLDWIDE

The International Forum for 8mm, 16mm, and 9.5mm film
Dedicated To Collectors Around The World
It is currently Mon May 06, 2024 9:36 am

Board index » 8mm Discussion

All times are UTC - 5 hours [ DST ]

Click on any of the boxes below to link to a new page



Screening Rooms    Ebay Film Sellers    Film/Equipment Sellers    Laurel and Hardy    Magnetic Striping


Our mission is to provide a "free" forum for all members. This forum will not delete, lock up, or edit any posts. On this forum, you are "free" to question any statement that is not understood, and debate any differences you have with another member. We only moderate when a member will not back up his accusations. There are no condescending attitudes from the Administrator or the Moderator. You will be treated with respect. Dan Lail, Admin. and Chris Smith, Moderator



Post new topic Reply to topic  Page 2 of 2
  [ 12 posts ]  Go to page Previous  1, 2
  Print view Previous topic | Next topic 
Author Message
Dan Lail
 Post subject: Re: Lower pulley vibration on ELMO 1200?
PostPosted: Mon May 12, 2014 10:20 pm 
Offline
Site Admin
User avatar

Joined: Tue Apr 26, 2011 4:51 pm
Posts: 2011
Location: Loganville, Ga.
Great, Roger! Glad to hear she's running smooth again.

_________________
And now For Our Feature Presentation.

http://www.metroxpressjazz.com/index.html
Top
 Profile Send private message  
 
Roger Cathey
 Post subject: Re: Lower pulley vibration on ELMO 1200? FOUND THE PROBLEM!
PostPosted: Tue Jun 24, 2014 12:41 pm 
Offline
Film Expert
User avatar

Joined: Tue Nov 01, 2011 2:59 pm
Posts: 540
Location: Friendship TN
After a little more investigation I found that the fan was touching the rear of the casing when running in reverse. I couldn't loosen the adjusting screws going in from the front side of the projector so I heated the plastic fan with a hair dryer and used a screw driver to pry the fan away from the rear of the casing. Each time that I pried a section I ran the machine and then moved to another area until I found where it was touching. I now can use the belt tensioner and proper belt and still have a smooth running projector. [set5_b/set5_b/party.gif]
Top
 Profile Send private message  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 2 of 2
  [ 12 posts ]  Go to page Previous  1, 2

Board index » 8mm Discussion

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group