| 8MM FORUM WORLDWIDE https://8mmforumworldwide.com/ |
|
| Bell & Howell 483Z Super 8 Projector Manual https://8mmforumworldwide.com/viewtopic.php?f=7&t=2408 |
Page 1 of 1 |
| Author: | John Reid [ Wed Oct 03, 2018 2:20 am ] |
| Post subject: | Bell & Howell 483Z Super 8 Projector Manual |
Hi: I would appreciate it if anyone could give me a source for the B & H 483Z Autoload Projector Manual? (pdf format copy would be OK) Thx John |
|
| Author: | Ken Layton [ Fri Oct 05, 2018 1:36 am ] |
| Post subject: | Re: Bell & Howell 483Z Super 8 Projector Manual |
How about this: http://www.texsales.com/proddetail.php?prod=SM7350 |
|
| Author: | John Reid [ Fri Oct 05, 2018 6:55 pm ] |
| Post subject: | Re: Bell & Howell 483Z Super 8 Projector Manual |
Thx for the suggestion. I paid only US60 for Projector - so this option for Manual (US40 including postage) is quite pricey! Was hoping there might be an on-line source at lower cost? Thx anyway - much appreciated. John |
|
| Author: | Ken Layton [ Fri Oct 05, 2018 9:57 pm ] |
| Post subject: | Re: Bell & Howell 483Z Super 8 Projector Manual |
That is the only place I have ever seen a manual for that model of projector. In general, there are a great many projector manuals that have never been scanned and are only available as hard copies. |
|
| Author: | John Reid [ Sat Oct 06, 2018 2:29 pm ] |
| Post subject: | Re: Bell & Howell 483Z Super 8 Projector Manual |
Thanks Ken. That makes things clearer. I did find one for Model 459 - quite similar - here: http://www.film-tech.com/warehouse/manuals/BH459.pdf My 483 received yesterday (eBay) seems little used and runs film OK - but very noisy - emanating from area of fan(s) - could be bearings/ belts, or gear train ie long-time-no-lube? Most hardware seems to be secured to front plate so I removed six holding screws to allow front plate to separate from housing - but something (apart from film cutter) is still holding housing . . . Would like to clean up gears, check belts and re-lube. Have seen SuperLube suggested as OK to avoid damage to (nylon?) gears. Would appreciate any tips - including best lube for projector moving parts? Thanks again. John |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|