| 8MM FORUM WORLDWIDE https://8mmforumworldwide.com/ |
|
| Elmo St 1200 -50HZ or 60HZ? https://8mmforumworldwide.com/viewtopic.php?f=6&t=1395 |
Page 1 of 1 |
| Author: | Roger Cathey [ Wed Dec 04, 2013 5:40 pm ] |
| Post subject: | Elmo St 1200 -50HZ or 60HZ? |
Does the drive belt on the ST1200 suppose to be on the 50HZ or 60HZ side of the pulley? |
|
| Author: | Mike Sands [ Wed Dec 04, 2013 6:13 pm ] |
| Post subject: | Re: Elmo St 1200 -50HZ or 60HZ? |
60HZ in the US |
|
| Author: | Roger Cathey [ Wed Dec 04, 2013 6:57 pm ] |
| Post subject: | Re: Elmo St 1200 -50HZ or 60HZ? |
Thanks Mike, Is 60HZ on the front pulley? |
|
| Author: | Mike Sands [ Wed Dec 04, 2013 7:13 pm ] |
| Post subject: | Re: Elmo St 1200 -50HZ or 60HZ? |
Its the groove towards the front of the projector. I have a 1200D. I took the cover off just to double check. I could not remember since I hardly use it. |
|
| Author: | Roger Cathey [ Wed Dec 04, 2013 8:40 pm ] |
| Post subject: | Re: Elmo St 1200 -50HZ or 60HZ? |
Thanks, I just purchased one from eBay that had trouble rewinding a full film. The seller tried everything he knew and finally moved the belt back to the rear groove. He said that it put more tension on the belt and after tightening the tension spring it is within 3 seconds of recommended rewinding time. I thought the belt should be in the front position. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|