8MM FORUM WORLDWIDE • View topic - NEED PART FOR EUMIG 807D or 810D (or possibly 802)

8MM-16MM FORUM WORLDWIDE

The International Forum for 8mm, 16mm, and 9.5mm film
Dedicated To Collectors Around The World
It is currently Fri Mar 29, 2024 8:51 am

All times are UTC - 5 hours [ DST ]

Click on any of the boxes below to link to a new page



Screening Rooms    Ebay Film Sellers    Film/Equipment Sellers    Laurel and Hardy    Magnetic Striping


Our mission is to provide a "free" forum for all members. This forum will not delete, lock up, or edit any posts. On this forum, you are "free" to question any statement that is not understood, and debate any differences you have with another member. We only moderate when a member will not back up his accusations. There are no condescending attitudes from the Administrator or the Moderator. You will be treated with respect. Dan Lail, Admin. and Chris Smith, Moderator



Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: NEED PART FOR EUMIG 807D or 810D (or possibly 802)
PostPosted: Wed Sep 12, 2012 8:27 pm 
Offline
Film Expert
User avatar

Joined: Sun Jun 05, 2011 4:45 am
Posts: 161
Location: Hillside, N.J.
Does anyone have a Eumig 807D, 810D or a non dual 8 machine for parts? Possibly and 802 would help.

There's one particular part I am looking for. I don't have a name for it since I don't have a service manual.

When the rear cover is removed, the spindle assembly that leans toward FWD and REV rubber pads sits in front of a small stabilizer block; almost resembling a pad lock (square on bottom and round atop) with three holes for screws to mount. That's the part I need. It should have a yellow plastic non removable washer inside. That's the MOST important part and the reason why I need this (the yellow washer cracked and thus rendered that area useless). The two screws should have gray, dried latex (which means Eumig didn't want anyone removing it them; but can be removed with a fine screw driver and some WD40, if need).

I have a pic of the part that is useless but could display so one can compare. Thanks for any help in locating.


John


Top
 Profile Send private message  
 
 Post subject: Re: NEED PART FOR EUMIG 807D or 810D (or possibly 802)
PostPosted: Sat Sep 15, 2012 1:53 pm 
Offline
Film Expert
User avatar

Joined: Sun Jun 05, 2011 4:45 am
Posts: 161
Location: Hillside, N.J.
PART FOUND!


Top
 Profile Send private message  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group