8MM FORUM WORLDWIDE https://8mmforumworldwide.com/ |
|
NEED PART FOR EUMIG 807D or 810D (or possibly 802) https://8mmforumworldwide.com/viewtopic.php?f=22&t=868 |
Page 1 of 1 |
Author: | John Capazzo [ Wed Sep 12, 2012 8:27 pm ] |
Post subject: | NEED PART FOR EUMIG 807D or 810D (or possibly 802) |
Does anyone have a Eumig 807D, 810D or a non dual 8 machine for parts? Possibly and 802 would help. There's one particular part I am looking for. I don't have a name for it since I don't have a service manual. When the rear cover is removed, the spindle assembly that leans toward FWD and REV rubber pads sits in front of a small stabilizer block; almost resembling a pad lock (square on bottom and round atop) with three holes for screws to mount. That's the part I need. It should have a yellow plastic non removable washer inside. That's the MOST important part and the reason why I need this (the yellow washer cracked and thus rendered that area useless). The two screws should have gray, dried latex (which means Eumig didn't want anyone removing it them; but can be removed with a fine screw driver and some WD40, if need). I have a pic of the part that is useless but could display so one can compare. Thanks for any help in locating. John |
Author: | John Capazzo [ Sat Sep 15, 2012 1:53 pm ] |
Post subject: | Re: NEED PART FOR EUMIG 807D or 810D (or possibly 802) |
PART FOUND! |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |