Hi all,
Anyone know for one, what this board is called?
2/ Where could one get it from, board has shorted I think, as no power according to my multi meter is coming out of the two terminal blades which is where the red for power and black Negative are on left hand side of board. Yet when I multi Meter right side wiring, blue etc, I get up to 18 plus volts.
I don't know enough about thee boards to check what may be wrong, but solder looks okay on back, but when I got Unit, this board was somewhat loose and missing spacers for where you screw black back board onto projector.
If I knew what it was called, I might be able to pick one up from a couple of electronics shops here in Australia, like what is RadioShack is in USA.
There is writing on back board, I can just make out some of it. Looks like ES 19 94H8
Refer pictures below, board sits in top right hand corner of projector when looking from behind and sends power to the micro switches that the selector knob uses to run projector.
thanks in advance Phil
Attachments: |
Speed Control board back part with Transistor.JPG [ 48.63 KiB | Viewed 1949 times ]
|
Speed Control PCB Back.JPG [ 238.86 KiB | Viewed 1949 times ]
|
Speed Control PCB smaller.jpg [ 104.8 KiB | Viewed 1949 times ]
|
|