| 8MM FORUM WORLDWIDE https://8mmforumworldwide.com/ |
|
| need part for Elmo ST 600 or St 180 https://8mmforumworldwide.com/viewtopic.php?f=22&t=1248 |
Page 1 of 1 |
| Author: | John Capazzo [ Thu Jun 20, 2013 8:31 pm ] |
| Post subject: | need part for Elmo ST 600 or St 180 |
Does anyone have the black film guide for any of the Elmo ST 600 or 180 machines? It's located right before the lower sprocket and held with two screws. John |
|
| Author: | Chris Smith [ Sat Jun 22, 2013 1:50 pm ] |
| Post subject: | Re: need part for Elmo ST 600 or St 180 |
John-- I have no idea what those model machines look like inside. The reason I mention, I do have an ST-1200 parts machine--would the film guide from a 1200 work in those? If so, it's yours. |
|
| Author: | John Capazzo [ Sat Jun 22, 2013 2:32 pm ] |
| Post subject: | Re: need part for Elmo ST 600 or St 180 |
Thanks for the reply, but the ST 1200 has a different guide than ST 600. John |
|
| Author: | Steve Klare [ Mon Jun 24, 2013 8:06 am ] |
| Post subject: | Re: need part for Elmo ST 600 or St 180 |
Hey John, Denevi Digital Imaging actually has inventory of new replacement parts for Elmo and one of their specialty machines is ST-180. http://www.denevi.com/elmo/ I needed a replacement film tensioner for my ST-800 a few months back and I bought it from them. They were pretty nice to deal with and the part is fine. I'm not 100% sure this is old Elmo stock: it's black plastic instead of the green the worn part was. |
|
| Author: | John Capazzo [ Mon Jun 24, 2013 10:07 pm ] |
| Post subject: | Re: need part for Elmo ST 600 or St 180 |
Thanks, Steve. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|