| 8MM FORUM WORLDWIDE https://8mmforumworldwide.com/ |
|
| Elmo 16-CL Deluxe MO projector help https://8mmforumworldwide.com/viewtopic.php?f=13&t=2634 |
Page 1 of 1 |
| Author: | Dave Watts [ Sat Apr 25, 2020 5:12 pm ] |
| Post subject: | Elmo 16-CL Deluxe MO projector help |
I have an Elmo 16-CL Deluxe MO projector is in need of some TLC. I dug it out of storage and it needs new pinch rollers for sure which seems to be a common problem with these. Before I invest in those, I have an issue with the projector itself. As soon as I plug it in, it runs. The switches on the side make no difference, it runs when plugged in. I do have a 16-CL service manual and was able to cobble together some info on the circuit for that projector but the big issue is the circuit board with the 4 switches on it. Does anyone have a schematic for this projector ir just that circuit board? I think that this model had the 4 switches instead of the large selector knob found on most 16-CLs. I was able to determine that the actual switches are working fine and have tested all diodes, resistors and capacitors on the circuit board and all seem fine. I actually was also able to test all of the logic chips and I think I may have a bad one so it is on order to be replaced but it would be very helpful to have a service manual or schematics for this projector. Anyone have such a thing? Appreciate any and all help given. Thanks Dave |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|