| 8MM FORUM WORLDWIDE https://8mmforumworldwide.com/ |
|
| ELMO CL-16 What is this nut and screw and what are for. https://8mmforumworldwide.com/viewtopic.php?f=13&t=1219 |
Page 1 of 1 |
| Author: | Roger Cathey [ Thu May 30, 2013 9:04 pm ] | ||
| Post subject: | ELMO CL-16 What is this nut and screw and what are for. | ||
I noticed that this nut and screw had been turned on this CL-16. The nut above the exciter lamp and the screw just below and left of the lamp next to the glass on the sound head. What do these adjust if anything?
|
|||
| Author: | Richard C Patchett [ Fri May 31, 2013 11:52 am ] |
| Post subject: | Re: ELMO CL-16 What is this nut and screw and what are for. |
Greetings This is the adjustment for the buzz tarck RC |
|
| Author: | Roger Cathey [ Fri May 31, 2013 12:46 pm ] |
| Post subject: | Re: ELMO CL-16 What is this nut and screw and what are for. |
Thanks Richard, What exactly does the buzz track do and how is it adjusted? |
|
| Author: | Richard C Patchett [ Fri May 31, 2013 3:15 pm ] |
| Post subject: | Re: ELMO CL-16 What is this nut and screw and what are for. |
Send me your email address ill send the service manual page That explains patchetts@ameritech.net |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|